Intermec PC4

Chapter 4 — ESim Commands
106 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
p
1
= 31 mm (248 dots)
p
2
= 7.0 mm (56 dots)
p
3
= 17 mm (136 dots)
Example 2: Printing in Between Perforations
The Q command would be:
Q248,B56-136 
q - Set Label Width
Purpose: Use this command to set the label width when using less than full
width labels.
Syntax: qp
1
.
p
3
p
2
p
1
Perforation
q Command Parameter Descriptions
Parameter Description
p
1
Width of label measured in dots.
Default:
832 at 203.dpi (8 dots/mm)
1208 at 300 dpi (11.81 dots/mm)