Chapter 4 — ESim Commands
74 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
Mode 1, 2, and 6 changes the output in a similar way.
All parameters are saved in flash memory. If more than one error
occurs at the same time, there is an output for each error recovery, like
<p
1
>00<CRLF> on mode 2. For more information on error
handlings see, “Error Handling Principles” on page 156.
Example:
f - Cut Position
Purpose: Use this command to adjust the cutting position along the y-axis in
relation to the media according to other characteristics of individual
printers and batches of media.
Syntax: fp
1
.
Command
Manual
Action
Reply Comments
US 8
<ACK>
Enables erro
r repor
ting.
eRC,2,Q 8 Reply error with
character “C” and error
NN and at recovery with
character “Q”.
Open
cover
C11<CRLF> Manual action generates
error 11.
Close
cover
Q00<CRLF> Manual recovery on
error 11.
f Command Parameter Descriptions
Parameter Description
p
1
Cut position index measured in dots:
203.2 dpi (8 dots/mm):
Recommended: 070 - 130
Minimum/Maximum: 020 - 180
Default is 100
300 dpi (11.81 dots/mm):
Recommended: 050- 150
Minimum/Maximum: 000 - 200
Default is 100
To Next Page
Loading...
