Intermec PC4

Chapter 4 — ESim Commands
ESim for the PC4 and PF8 Printers Programmer’s Reference Manual 117
Remarks: Default is no Command Reply Accept Character (command UC0).
Parameter p
1
saves in Flash.
If command UC is activated, it replaces the <ACK> character at the
end of command US and P.
If an error occurs and error report is activated, the error message is
sent instead.
Example:
The table below shows an example of the UC command with the a
reply.
UDC - Memory Cartridge Information (PC4 only)
Purpose: Use this command to check an inserted memory cartridge and to
return information on the cartridge’s contents on the RS-232 or USB
channel.
Syntax: UDC
Remarks: This command checks the memory cartridge for the following
information and returns one of the following alternatives listed in the
table below.
Command Reply Explanation
UC062 8 > Set Command Reply Accept
character to “>”.
US 8 > Reply error.
X50,200,5,400,20 8 > Draw a box.
P 8 > Print box and reply “>” at
ready.
Memory Cartridge Commands and Explanations
Command Explanation
NA 8 Cartridge not detected.
000 8 Cartridge detected, but no relevant
information is found.