Intermec PC4

Chapter 2 — Sending ESim Commands to the Printer
14 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
To resume printing a paused print job
• In Print mode, enter the ^C command or press the Feed button.
The printer resumes printing.
To stop printing
• In Print mode, use the ^B command. The printer breaks the
printing of the paused print job. For help, see “^D - Remaining
Labels” on page 65.
Resetting to Factory Default Settings
To restore the factory default settings, do one of the following:
• Press and hold the Feed button for more than 3 seconds.
• Start the ESim Config Tool and click Restore Factory Defaults
on the Setup tab.
• Send the ^default command to the printer.
Default Setup
This table lists the default settings on the PC4 or PF8 printers.
Default Printer Settings
Parameter Command Default Setting
Error/status
character
eR0,0 XOFF/XON-handling
Density D10 10
Character set I8,0,001 8 bits, code page 0, country code 001
Top of form backup JF Enabled
Media feed adjust J136
J204
136 dots at 203.2 dpi
204 dots at 300 dpi
Label gap sensor ON LTS, TT mode, reverse gap, and cutter disabled.
Character
substitution
oR No substitution
Form length Q24,0 Continuous mode, print gap 24 dots
Label width q832
q1208
832 dots at 203.2 dpi
1208 dots at 300 dpi