Intermec PC4

Chapter 4 — ESim Commands
78 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
Startup Form
A special case of forms is the startup form, that is automatically
retrieved and prompted for variables (if necessary) each time power is
applied to the printer. A startup form is created by naming the form
"AUTOFR". To exit the "AUTOFR" mode, send XOFF or NULL to
the printer on the serial interface.
Always test the form using another name before making it a startup
form. If a startup form causes an error, there are two ways of clearing
it:
• If the indicator lamp shines green, send XOFF or NULL to exit
“AUTOFR” mode. Then delete the startup file using
FK“AUTOFR”.
• If the indicator lamp shines orange, there is no communication
and the memory must be erased by pressing the Feed button for
more than 3 seconds in Dump mode.
GG - Print Graphics
Purpose: Use this command to print a graphic that has been previously stored
in memory.
Syntax: GGp
1
,p
2
,“name”
.
Remarks: A graphic can only be printed in the same direction and size as when it
was saved. There are no means of magnification or rotation of an
individual graphic. However, the entire print image including all text,
bar codes, graphics, lines, and boxes can be rotated 180° using the Z
command.
GG Command Parameter Descriptions
Parameter Description
p
1
Horizontal start position (X) in dots.
p
2
Vertical start position (Y) in dots.
“name” This is the name used when the graphic was
stored. The name may be from 1 to 8
characters. The printer is case sensitive, so the
use of upper and lowercase letters must match
the original name.