Intermec PC4

Chapter 4 — ESim Commands
116 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
• Short labels
PF8 Printer Configuration Label Example
UC - Command Reply Accept Character Control
Purpose: Use this command to specify a prompt to acknowledge characters
which the printer returns on the RS-232 or USB channel to the host
after each command execution with no error reply before proceeding
with the next command.
Syntax:
UCp
1
.
UC Command Parameter Descriptions
Parameter Description
p
1
Specifies the desired reply character by its
ASCII decimal value (0-255).
If p
1
is anything other than numerical
characters or the value is 0, there is no
Command Reply Accept character (default).