Intermec PC4

Chapter 4 — ESim Commands
ESim for the PC4 and PF8 Printers Programmer’s Reference Manual 65
^D - Remaining Labels
Purpose: Use this high priority commto make the printer return the number of
labels remaining to be printed in a batch print job.
Syntax: ^D
Remarks: The reply at command US is by default Pnnnn<CR><LF>, where nnnn
is the number of remaining labels.
This command can only be sent via the RS-232 or USB ports.
Example:
Duratran II Premium D5 S3
Duratran II Tag Premium D6 S2
Kimdura Premium D6 S3
Matte Polyester Premium D6 S3
Gloss Polyester Super
premium
D7 S3
TTR Uncoated GP02 D1 S2
TTR Matte Coated HP05 D6 S3
TTR Premium HP05 D4 S3
TTR Premium Board HP05 D7 S1
TTR Polyethylene HP05 D2 S3
TTR Gloss Polyethylene HP05 D7 S3
TTR High Gloss White
Premium
HP05 D7 S3
TTR Matte Coated HP07 D7 S3
TTR Premium Board HP07 D8 S1
TTR Polyethylene HP07 D4 S3
TTR Gloss Polyethylene HP97 D8 S3
TTR High Gloss White
Premium
HP07 D9 S3
TTR High Gloss Polyester HR03 D7 S3
Recommended Density Settings For Thermal Transfer Printing
Label/Tag Type Ribbon Type
Recommended
Density at Speed S
= 2
Maximum
Speed