Chapter 4 — ESim Commands
64 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
Test after the print speed has been set, see “S - Speed Select” on
page 110, and make further adjustments until you have found the
settings which best apply to your unique application.
Example:
To select a printhead density of 9, enter the command below:
D9
Recommended density settings are identified in the following tables.
Further adjustments might be necessary depending on print speed,
bar code density, orientation, and ambient temperature/humidity
conditions.
Recommended Density Settings For Direct Thermal Printing
Label/Tag Type
Recommended
Density at Speed
S = 2
Maximum Speed
Duratherm II D10 S3
Duratherm II Tag D9 S1
Duratherm Lightning D9 S3
Duratherm IR D7 S3
Thermal Top D8 S3
Thermal Eco D8 S3
Thermal Top Board D11 S2
Thermal Eco Board D7 S2
Thermal IR D12 S3
Thermal Top High Speed D6 S3
Duratherm Lightning D9 S3
Recommended Density Settings For Thermal Transfer Printing
Label/Tag Type Ribbon Type
Recommended
Density at Speed S
= 2
Maximum
Speed
Duratran II Standard D4 S3
Duratran II Tag Standard D4 S2
To Next Page
Loading...
