Intermec PC4

Chapter 4 — ESim Commands
ESim for the PC4 and PF8 Printers Programmer’s Reference Manual 47
Remarks: The standard program packages contain all the two-dimensional bar
codes mentioned above.
If the amount of data does not fit in the area specified, the indicator
turns orange, indicating an error.
b - EAN/UCC Composite-Code
Purpose: The following EAN/UCC Composite-Code bar code specific options
should append the general part of the two-dimensional bar code
command (indicated by the italicized characters, see “b - Two-
Dimensional Bar Codes, General Part” on page 46 for more
information. Presently, only EAN/UCC-128 with CC-C is supported.
Syntax: bp
1
,p
2
, p
3
, p
4
,o,x,y,s,1,[B,][P][F,]M,“Data
1
| Data
2
”
b - EAN/UCC Command Parameter Description
Parameter Description
p
4
Selection of bar code type
(linear part and two-dimensional part)
1EC and EAN/UCC-128 with CC-C
o0 = No rotation
1 = 90° rotation clockwise
2 = 180° rotation clockwise
3 = 270° rotation clockwise
Limit is 0-3.
Default is 0.
x Module width of pixel size in dots,
magnification of both linear and 2D composite
component.
Limit is 1-10
Default is 2.
y Bar height on linear part in dots.
Limit is 2-999.
Default is 100.