Intermec PC4

Chapter 4 — ESim Commands
98 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
.
Remarks: The oR command is a global printer command and:
• cannot be issued inside a form.
• must be issued prior to issuing a text command and printing it.
• affects a single character on all code pages. Changing the character
position restores the original character.
• flash memory printer parameter data is preserved until changed
by the oR command, or the printer is reset to default.
Example:
oRE 
oRE,128 
oR 
P - Print
Purpose: Use this command to print the contents of the image buffer.
Syntax: Pp1[,p2]
Remarks: You cannot use the P command inside a stored form sequence. For
automatic printing of stored forms, use the PA command.
Example: This example prints two label sets of one label each, see the
command below:
P2,1 
oR Command Parameter Descriptions
Parameter Description
p
1
If p
1
= E, the Euro character is mapped to the
code page position specified by p
2
. If no p
1
or
p
2
parameters are give, all code pages are reset
to the original default character mapping.
p
2
Specifies the code page position for the Euro
character in the range ASCII 32-255 decimal
for all code pages, provided p
1
= E. If p
2
is
omitted, the Euro character is mapped to the
code page position ASCII 213 decimal for all
code pages provided that p
1
= E.