Intermec PC4

Chapter 4 — ESim Commands
ESim for the PC4 and PF8 Printers Programmer’s Reference Manual 73
Remarks: Exception of output: Error 07 “Out of media or ribbon,” is added after
07 with Pnnn or Rnnn, where nnn = number of remaining labels:
Output at error media action (mode 0):
<NAK>07Pnnn<XOFF>
Output at error ribbon action (mode 0):
<NAK>07Rnnn<XOFF>
Output at error recovery:
<XON>
p
2
Mode of User Defined Error/Status Character
reply (one ASCII numerical:
p
2
= 0 Mode of Reply Default, where error
number is NN:
Output at error action: <NAK>NN<XOFF>
Output at error recovery: <XON>
p
2
= 1 Mode of Reply only with character,
defined by p
1
:
Output at error action: <p
1
><CRLF>
Output at error recovery: <p
3
><CRLF>
p
2
= 2 Mode of Reply with character p
1
and
error number NN:
Output at error action: <p
1
>NN<CRLF>
Output at error recovery: <p
3
>00<CRLF>
p
2
= Mode of <XOFF> and <XON>
replacement:
Like default mode (0), but with all <XOFF>
replaced by p
1
and all <XON> replaced by
optional p
3
:
Output at error action: <NAK>NN<p
1
>
Output at error recovery: <p
3
>NN
p
3
Optional recovery action single character:
The normal recovery character <XON> is
replaced by p
3
. Value of p
3
is one single ASCII
character, except hex 00. If no p
3
is available,
p
1
is used instead as a recovery action
character.
eR Command Parameter Descriptions (continued)
Parameter Description