Chapter 4 — ESim Commands
ESim for the PC4 and PF8 Printers Programmer’s Reference Manual 129
Remarks: This command affects the complete print image, including text, bar
codes, graphics, lines, and boxes, as well as the location f the reference
point, see “R - Set Reference Point” on page 107.
A label printed using the command ZT
A label printed using the command ZB
Example:
This example makes the printer print from the bottom of the image,
see command below.
ZB
Note: that printing a test label in the Test modes or using a
U or UP command resets the print direction to default (ZT).
EASYCODER PC4
Feed Direction
EASYCODER PC4
Feed Direction
To Next Page
Loading...
