Goodrive200 inverters Basic operation instruction
Function Instructions
22 ACC/DEC time selection 2
1
Terminal
2
ACC/DEC time
selection
Corresponding
parameter
OFF OFF ACC/DEC time 1
23 Simple PLC stop reset
Restart simple PLC and clear the memory state of
PLC.
24 Simple PLC pause
Program pause during PLC implement. Run at the
current speed step. After cancel the function, simple
PLC continues to run.
25 PID control pause
Temporal PID invalid and the inverter will output at the
current frequency.
26
Traverse pause (stop at the
current frequency)
The inverter will stop at the current output and after
canceling the function, the inverter will continue to
traverse run at the current frequency.
27
Traverse reset (return to the
middle frequency)
The setting frequency of the inverter will come back to
the middle frequency.
28 Counter reset Counter clear
29 Torque control prohibition
Switch from torque control mode to speed control
mode
30 ACC/DEC disabling
Ensure the inverter will not be affected by the external
signals (except for the stopping command) and keep
the current output frequency.
31 Counter trigging Enable the pulse counter.
32 Length reset Length counter clear
33
Frequency
increasing/decreasing setting
temporal clear
When the terminal closes, the frequency set by
UP/DOWN can be cleared. All set frequency will be
restored into the reference frequency by the
frequency command channel and the frequency will
To Next Page
Loading...
Need help?
General