INVT GD200-037G/045P-4 - Page 91

Goodrive200 inverters Function codes
90
Function
code
Name
Detailed instruction of parameters
Default
value
Modify
displayed. Unless input right password, the
operator can not enter into it.
Note: Restoring to the default value can clear the
password, please use it with caution.
P07.01
P
arameter
copy
The function code determines the mode of
parameters copy.
0:No operation
1:Upload the local function parameter to the
keypad
2:Download the keypad function parameter to
local address(including the motor parameters)
3:Download the keypad function parameter to
local address (excluding the motor parameter of
P02 group)
4:Download the keypad function parameters to
local address (only for the motor parameter of
P02 group)
Note: After completing the 1~4 operation, the
parameter will come back to 0 automatically, the
function of upload and download excludes the
factory parameters of P29.
0 ◎
P07.02
QUICK/JO
G
function
selection
0:No function
1: Jogging. Press QUICK/JOG to begin the
jogging running.
2: Shift the display state by the shifting key.
Press QUICK/JOGto shift the displayed function
code from right to left.
3: Shift between forward rotations and reverse
rotations. Press QUICK/JOG to shift the direction
of the frequency commands. This function is only
valid in the keypad commands channels.
1 ◎