ITech IT7900 Series

SYSTem Commands
Copyright © ITECH Electronic Co., Ltd. 20
Default value
ON
Returns
OFF/ON
Example
SYST:BEEP OFF
Related syntax
SYSTem:BEEPer[:STATe]?
SYSTem:COMMunicate:USB:TYPE <CPD>
This command is used to set and query the USB interface type. IT7900 series
power supply USB can be set as the host or device type, used to set the USB
interface for communication or as a storage disk. When set as host type, it is used
as a storage disk, and when set as device type, it is used as a communication
interface.
Syntax
SYSTem:COMMunicate:USB:TYPE <CPD>
Arguments
DEVice|HOST
Defaults
HOST
Returns
DEVice|HOST
Example
SYST:COMM:USB:TYPE HOST
Query syntax
SYSTem:COMMunicate:USB:TYPE?
SYSTem:COMMunicate:SELect <CPD>
This command is used to set and query the communication method. This series
instrument comes standard with four communication interfaces: USB, LAN, VCP
and CAN, and supports two optional communication interfaces: GPIB, RS-232.
And the RS232 and GPIB options can be selected only after the communication
board corresponding to RS232 and GPIB is successfully inserted into the
corresponding position on the rear panel of the instrument.