SYSTem Commands
Copyright © ITECH Electronic Co., Ltd. 24
SYSTem:COMMunicate:LAN:DGATeway <SPD>
This command is used to set and query the gateway address of the LAN
communication.
Syntax
SYSTem:COMMunicate:LAN:DGATeway <SPD>
Arguments
<SPD>
Default value
"192.168.0.1"
Example
SYST:COMM:LAN:DGAT "192.168.0.1"
Query syntax
SYST:COMM:LAN:DGAT?
SYSTem:COMMunicate:LAN:RAWSocketport <port>
This command is used to set and query the socket port of the LAN
communication.
Syntax
SYST
em:
COM
Municate:LAN:RA
WSocketport <p
ort>
Arguments
<SPD>
Default value
"30000"
Example
SYSTem:COMMunicate:LAN:RAWSocketport 30001 //Set the socket port to
30001
Query syntax
SYSTem:COMMunicate:LAN:RAWSocketport? //Query the socket port of
LAN interface.
SYSTem:FUNCtion <CPD>
This command is used to set and query the present power supply mode, including
single-phase/three-phase/reverse/multi-channel.
Syntax
SYSTem:FUNCtion <device>
To Next Page
Loading...
