Routine Maintenance
Transmission
167 167
9811-3400-4
Changing the Oil
1 Make the machine safe with the loader arm lowere.
Refer to Prepare the Machine for Maintenance.
2 Clean the area around the fill/level plug A.
3 Remove the fill/level plug A and its seal.
4 Put a suitable container below the drain plug B (to
catch the oil).
5 Remove the drain plug B and let the oil drain fully into
the container.
!MCAUTION
Oil will gush from the hole when the drain plug is
removed. Keep to one side when you remove the plug.
2-3-4-2
6 Clean then install the drain plug B and its seal. The
drain plug B is magnetic, make sure all unwanted
material is removed.
7 Tighten the drain plug B to 85 Nm (60 lbf ft).
8 Fill the axle with the recommended oil through fill/
level plug A.
9 Clean then install the fill/level plug A and its seal.
10 Tighten the fill/level plug A to 85 Nm (60 lbf ft).
S217950-1
Fig 124.
To Next Page
Loading...
