Routine Maintenance
Transmission
169 169
9811-3400-4
Changing the Hub Oil
Note: You must do the hubs separately.
1 Make the machine safe with the loader arm lowered.
Refer to Prepare the Machine for Maintenance.
Make sure the fill/drain plug A is at the bottom, as
shown. K
Fig 126. ( T 169).
T005570-2
Fig 126.
2 Clean the area around the fill/drain plug A.
3 Put a suitable container below the fill/drain plug A. (to
catch the oil).
4 Remove the fill/drain plug A and its seal and let the oil
drain fully into the container.
!MCAUTION
There will be no oil in the hub when the machine is
driven forward. Only drive the machine forward one
quarter revolution of the wheel. Do not drive the
machine more than is necessary.
4-3-5-1
5 Drive the machine slowly forward to put the OIL
LEVEL mark on the hubs into the horizontal position,
as shown. K Fig 127. ( T 169).
T005570-1
Fig 127.
6 Fill the hub with the recommended oil through the fill/
drain plug A until oil starts to come out.
7 Clean then install the fill/drain plug A and its seal.
8 Tighten the fill/drain plug A to 85 Nm (60 lbf ft).
To Next Page
Loading...
