Operation
Drive Controls, Switches and Instruments
51 51
9811-3400-4
System Faults (Error Message Only)
Error messages are displayed on the top line of the display
panel.
– IN GEAR
If Neutral is not selected, the panel will display the
message "IN GEAR" and the buzzer will sound.
– PARK BRAKE
If the park brake is on and the transmission is not in
neutral, the message "PARK BRAKE" will also be
displayed.
– START INHIBIT
The following warnings will also cause the "START
INHIBIT" message to be displayed. The engine will
not start until the fault is cleared.
Transmission Oil Temperature High (10)
Water Temperature High (23)
Emergency Steer Pump (19)
"START INHIBIT" can be overridden by pushing the
MANUAL button once.
– STEER SW FAULT
If there is a fault with the emergency steering, the
message "STEER SW FAULT" will be displayed and
the buzzer will sound.
– ZFCB ERROR ??
In the event of the transmission developing a fault, the
EMS will display a fault code to aid diagnosis.
A fault code will be displayed on the top line of the
display panel. An example of a fault code is shown:
"ZFCB ERROR B6".
A list of the fault codes is given in the Service Manual.
Setting Up
1 Turn on the power by turning the starter key to IGN.
2 Pressing the SETUP/SELECT button while in Pre-
Start Mode will allow the display to be set up as
follows:
Note: Use the up and down arrows to adjust display as
required.
a CLK FORMAT
The clock format (12/24 Hour) is shown in the top
right corner.
b HOUR
c AM/PM
With 12 Hour selected, AM or PM is selected and
is displayed in the top left corner.
d MINUTE
e YEAR
f MONTH
g DATE (Day)
h LANGUAGE
English is the default language, there is one
alternative language. Certain languages are not
available.
i Returns the display to Pre-Start Mode.
To Next Page
Loading...
