Operation
Drive Controls, Switches and Instruments
53 53
9811-3400-4
9 Hydraulic Fluid Temperature High
Audible/Visual with Message "HYD OIL TEMP"
displayed on the top line of the display panel.
Operates if the hydraulic fluid temperature rises too
high.
10# Transmission Oil Temperature High
Audible/Visual with Message "TRANS OIL TEMP"
displayed on the top line of the display panel.
Operates if the transmission oil temperature rises
too high.
11 Not used.
12 Not used.
13 Fuel Level
Visual Only. Flashes when only 10% of fuel is left in
tank.
14 Hazard Warning
Visual Only. Flashes with the hazard warning lights
(even with the starter switch at O). Switch the
flashers on whenever your machine is a possible
hazard.
15 Side Lights On
Visual Only. Lights up when the side lights are
switched on.
16 Dip Beam On
Visual Only. Lights up when the headlight dipped
lights are switched on.
17 Rear Work Lights On
Visual Only. Lights up when the rear work lights are
switched on.
18 Park Brake Engaged
Visual Only. Lights up when the park brake is
engaged.
19# Emergency Steer Pump
Visual with Message "EM STEER FAULT"
displayed on the top line of the display panel. Lights
up when the emergency steering system is
operating. ie. When the machine is moving.
Flashes when system fails to pressurise due to
system fault.
20 No Charge
Audible/Visual with Message "ALTERNATOR"
displayed on the top line of the display panel.
Operates when the battery charging circuit fails
while the engine is running. The light should go out
a few seconds after the engine is started.
21* Brake System Pressure Low
Audible/Visual with Message "BRAKE FAILURE"
displayed on the top line of the display panel. Lights
up when the brake system pressure is low.
22* Main Steer System
Audible/Visual with Message "STEERING PRESS"
displayed on the top line of the display panel. Lights
up if the main hydraulic system pressure fails. Stop
the machine as soon as it is safe to do so and
rectify the fault.
23# Water Temperature High
Audible/Visual with Message "COOLANT TEMP"
displayed on the top line of the display panel.
Operates if the engine coolant temperature rises
too high.
24* Air Filter Blocked
Audible/Visual with Message "AIR FLTER BLKD"
displayed on the top line of the display panel.
Operates if the engine air filter clogs up.
25 Not used.
26 Not used.
27 CAN-Bus Error
Visual Only. Illuminated if EMS receives a CAN-bus
error from the ZF Computer.
To Next Page
Loading...
