5-5
TAIKO Service Manual
CHAPTER
5
© 2006 Japan Cash Machine Co.Ltd. All rights reserved.
5-2-3. Communication Troubles
- When you cannot solve the problem even if you follow the in-
struction above, please contact JCM. See => 5-7. Product
Support
Symptom/Error Message Possible Causes Recovery Action
DIP switch setting is wrong.
Set all DIP Switches OFF and
supply the power to the TAIKO unit.
Connector is unplugged or is
not connected properly.
Connect all connector properly.
Connector pin is broken.
Verify if the connector pin is any
bend, broken or missing.
CPU board failure
Replace the CPU board. See=> 6-
2. Replacement of CPU board
Interface is wrong.
Verify if the interface is appropriate
with Host. If wrong, set the interface
properly. See=> 2-5. DIP Switch
Settings
Cannot communicate with
Host
To Next Page
Loading...
