JCM TAIKO - 7-2-1-1.Interface Connector Pin Assignment; X4:Serial(ID-003);Mdb;Pulse;Cctalk Specification

10
*1 Conditions for the I/O (Input/Output) column are from the acceptor side.
Pin No. Signal Name I/O *1 Function
1 ccTalk+ IN/OUT ccTalk Send/Receive Line
2 NC - Not Connected
3 NC - Not Connected
4 NC - Not Connected
5 NC - Not Connected
6 NC - Not Connected
7 VCC - 12V DC Power Supply
8 VSS - Power Supply GND
9 NC - Not Connected
10 NC - Not Connected
 
 
 ccTalk Communication
7-2-1-1. Interface Connector Pin Assignment
X4:Serial(ID-003)/MDB/Pulse/ccTalk Specification
- The following pin assignment is for TAIKO units with a blue JCM logo
label. If the logo is black, the pin assignment may differ. For details,
contact JCM.
Blue
Black
Pin No. Signal Name I/O *1 Function
1 NC - Not Connected
2 NC - Not Connected
3 RXD-
4RXD+
5 TXD-
6TXD+
7 VCC - 12V DC Power Supply
8 VSS - P o we r Sup p ly GND
9 NC - Not Connected
10 NC - Not Connected
IN
OUT
Data Receive Line
(Active when current is applied)
Data Send Line
(Active when current is applied)
 
 
 Serial(ID-003)/MDB Communication
*1 Conditions for the I/O (Input/Output) column are from the acceptor side.