Chapter 7 AutoTest Mode
AutoTests Tab
144 DSAM Help User Guide Rev. 001
– Edit AutoTest Settings – When the Choose an AutoTest screen
is displayed, use the arrow keys to select the following options
then press the Configure softkey.
–Video Channels – See “Configuring AutoTest for Video Chan-
nels” on page 89.
– Cable Modem – See “Configuring AutoTest for Cable Modem”
on page 88.
14 Press ENTER.
15 Press the Start softkey.
The results appear on the DOCSIS AutoTest screen.
Figure 135 AutoTest – DOCSIS in Progress
NOTE
The Help system on this meter is disabled during all tests while they
are in progress.
To stop the test, press the STOP softkey.
21128026 R001 DSAM Help User Guide.book Page 144 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
