Chapter 11 Measure Mode – Sweep Tab
Forward Sweep
DSAM Help User Guide Rev. 001 275
5 Press the Settings softkey.
6 Using the arrow keys, select one of the following options:
– Test Point Comp – Displays the Test Point Compensation
screen (“Test Point Compensation” on page 71).
– Telemetry Frequency… – Displays the Telemetry Settings
screen (“Configuring Telemetry Frequency” on page 86).
– Sweep Tilt and Limit… – Displays the Sweep Settings
screen (“Sweep Settings” on page 55).
7 Using the arrow keys and the alphanumeric keypad, highlight and
edit the parameters as needed.
8 Press the OK softkey.
Understanding
Forward Sweep
Results
The Forward Sweep measurement mode provides signal levels of all
frequency points which are then displayed on a graph.
Figure 249 Measure Mode – Forward Sweep
NOTE
All settings made in the Telemetry Settings screen are saved in the
active channel plan identified in the upper right-hand corner of the
screen. Be sure to select the appropriate channel plan for the net-
work you are working with.
21128026 R001 DSAM Help User Guide.book Page 275 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
