JDS Uniphase DSAM-3500 - Figure 220 Measure Mode - Voip Ongoing Call; Figure 221 Measure Mode - Voip Ready; Voip MOS Definitions

Chapter 9 Measure Mode – Service Tab
VoIP
DSAM Help User Guide Rev. 001 243
4 Using the arrow keys and the alphanumeric keypad, enter or
select a telephone number.
5 Press the OK softkey.
If the other party accepts the call, DSAM establishes a conversa-
tion.
6 Press the View softkey.
7 Using the arrow keys, select View MOS.
8 Press ENTER.
VoIP MOS Definitions See “Measurement Information Area” on page 222 for the following
definitions: Packet Loss, Delay, Jitter, MOS, and R-Value.
Figure 220 Measure Mode – VoIP Ongoing Call
Figure 221 Measure Mode – VoIP Ready
21128026 R001 DSAM Help User Guide.book Page 243 Thursday, February 5, 2009 2:02 PM