Chapter 5 Configuring the Meter
Configure – General Tab
36 DSAM Help User Guide Rev. 001
Configuring Date and
Time
To set the meter date and time
1 Press Configure.
2 Press the General softkey.
3 Using the arrow keys, select Date and Time.
4 Press ENTER.
5 Using the arrow keys, select the parameter you want to edit.
6 Press ENTER.
7 Using the arrow keys and the alphanumeric keypad, edit the
value.
8 Press ENTER.
Figure 21 Configure – General Tab: Date and Time
Figure 22 Configure – Set Date and Time
21128026 R001 DSAM Help User Guide.book Page 36 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
