JDS Uniphase DSAM-3500 - Chapter 8 Measure Mode - Basic Tab; Measure Mode - Basic Tab

8
DSAM Help User Guide Rev. 001 149
Chapter 8 Measure Mode – Basic Tab
This chapter describes the Measure Mode – Basic tab functionality.
Topics discussed in this chapter are as follows:
– “Basic Measurement Modes” on page 150
– “Level” on page 151
– “MiniScan” on page 158
– “Full Scan” on page 161
– “Tilt” on page 168
– “Constellation” on page 174
– “FDR” on page 180
– “Return QAM Generator” on page 184
– “QAM Ingress” on page 187
– “Hum Analysis” on page 190
– “DQI” on page 192
– “Return Loopback” on page 194
– “Reading Measurement Graphs” on page 196
– “Saving Results” on page 198
21128026 R001 DSAM Help User Guide.book Page 149 Thursday, February 5, 2009 2:02 PM