JDS Uniphase DSAM-3500 - Chapter 11 Measure Mode - Sweep Tab; Measure Mode - Sweep Tab

11
DSAM Help User Guide Rev. 001 271
Chapter 11 Measure Mode – Sweep Tab
This chapter describes the Measure Mode – Sweep tab functionality.
Topics discussed in this chapter are as follows:
– “Sweep Measurement Modes” on page 272
– “Forward Sweep” on page 273
– “Reverse Sweep” on page 279
– “Sweepless Sweep” on page 285
– “Reverse Alignment” on page 290
21128026 R001 DSAM Help User Guide.book Page 271 Thursday, February 5, 2009 2:02 PM