JDS Uniphase DSAM-3500 - Figure 32 Configure - Set Local Preferences; Table 20 Regional Preferences Parameters

Chapter 5 Configuring the Meter
Configure – General Tab
44 DSAM Help User Guide Rev. 001
5 Using the arrow keys, select the parameter you want to edit.
6 Press ENTER.
7 Using the arrow keys, select an option.
8 Press ENTER.
9 Press the OK softkey.
Figure 32 Configure – Set Local Preferences
NOTE
You can save time by choosing the Preset To parameter first. The
Preset To value determines the corresponding defaults for the other
options.
Table 20 Regional Preferences Parameters
Name Description
Language The language displayed in the user interface.
Options are English, French, German and Spanish.
(Other languages may be installed on your particu-
lar meter by the factory.) The default option is Eng-
lish.
NOTE:
You must restart the meter after chang-
ing the language for the new language to take
effect.
Preset To The country where the meter is used. The Preset To
value determines the corresponding defaults for the
other options. The default option is United States.
21128026 R001 DSAM Help User Guide.book Page 44 Thursday, February 5, 2009 2:02 PM