Chapter 5 Configuring the Meter
Configure – General Tab
DSAM Help User Guide Rev. 001 49
2 Press Configure.
3 Press the General softkey.
4 Using the arrow keys, select Clone.
5 Press ENTER.
6 Using the arrow keys, select Send settings from this meter.
7 Press the Select softkey.
8 Using the arrow keys and the Select softkey, select (or deselect)
the configuration group(s) you want to clone.
9 Press the OK softkey.
10 Press the Done softkey.
Figure 37 Configure – General Tab: Clone
Figure 38 Configure – Clone
21128026 R001 DSAM Help User Guide.book Page 49 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
Need help?
General
