Chapter 10 Measure Mode – Spectrum Tab
Field View
DSAM Help User Guide Rev. 001 263
21 Press the Settings softkey.
22 Using the arrow keys, select RSG Setup.
23 Press ENTER.
24 To set the Return Signal Generator Frequency between 5 and 55
MHz (Annex B) or 5 and 65 MHz (Annex A and Annex C), use the
arrow keys to highlight the Enter Desired Frequency field and
press ENTER. Using the arrow keys, step the frequency up or
down, or use the alphanumeric keypad to enter the frequency,
then press ENTER.
OR
Figure 241 Measure Mode – Field View
Figure 242 Measure Mode – Return Signal Generator
21128026 R001 DSAM Help User Guide.book Page 263 Thursday, February 5, 2009 2:02 PM
To Next Page
Loading...
