Johnson Controls FMS-2000C - Metasys N2 Network Configuration

FMS-2000C
LIT-12013504
19
Metasys N2 network setup
The Metasys N2 network can be enabled on the controller. You can adjust the Network address only.
Setting the network address for a Metasys N2 network
On the Metasys N2 network, you can set up a network address within the valid range of 1 to 255.
1. On the home screen, tap the Settings icon to enter the Settings menu.
2. To view network settings, tap Network.
3. On the NETWORK screen, tap Network Address.
4. To adjust the Network Address, move the slider towards the Plus icon to increase or the Minus icon to decrease the parameter.
You can also tap the Plus or Minus icon to make adjustments.
5. Optional: Tap the Revert icon to revert back to the previous setting.
6. To conrm the new settings, tap the Checkmark icon.