Juniper EX9214 Hardware Guide

XF ASIC A 1000 mV 1002 mV 11281 mA 11303 mW
XF ASIC B 1000 mV 997 mV 11015 mA 10981 mW
NOTE: The output is of an EX9208 switch. The output is similar for all EX9200 switches.
Figure 74 on page 241 shows installing an SF module in an EX9208 switch. The procedure is the same
for all EX9200 switches.
Figure 74: Installing an SF Module in an EX9200 Switch
NOTE: If you have a Juniper J-Care service contract, register any addion, change, or upgrade of
hardware components at hps://www.juniper.net/customers/support/tools/updateinstallbase/ .
Failure to do so can result in signicant delays if you need replacement parts. This note does not
apply if you replace exisng components with the same type of component.
241

Juniper EX9214 Specifications

General

Brand	Juniper
Model	EX9214
Category	Switch
Language	English