Changing the Reset Config Button Behavior on the SRX100 Services Gateway
You can change the default operation of the Reset Config button by limiting how the
button resets the services gateway:
■ To prevent the Reset Config button from setting the device to the factory default
configuration and deleting all other configurations, enter the following command:
user@host# set chassis config-button no-clear
You can still press and quickly release the button to reset it to the rescue
configuration.
■ To prevent the Reset Config button from setting the device to the rescue
configuration, enter the following command:
user@host# set chassis config-button no-rescue
You can still press and hold the button for 15 seconds or more to reset the
gateway to the factory defaults.
■ To disable the button and prevent the device from resetting to either
configuration, use the following command:
user@host# set chassis config-button no-clear no-rescue
The no-rescue option prevents the Reset Config button from loading the rescue
configuration. The no-clear option prevents the Reset Config button from deleting all
configurations on the services gateway.
To return the function of the Reset Config button to its default behavior, remove the
config-button statement from the device configuration.
Related Topics ■ Using the Reset Config Button on the SRX100 Services Gateway on page 85
■ Monitoring the SRX100 Services Gateway Chassis Using the CLI on page 79
■ Monitoring the SRX100 Services Gateway Components Using LEDs on page 81
■ Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on
page 83
■ Monitoring the SRX100 Services Gateway Power System on page 84
■ Juniper Networks Technical Assistance Center on page 87
Juniper Networks Technical Assistance Center
This topic includes the following section:
■ Juniper Networks Technical Assistance Center on page 87
86 ■ Changing the Reset Config Button Behavior on the SRX100 Services Gateway
SRX100 Services Gateway Hardware Guide
To Next Page
Loading...
