About This Guide
This topic includes the following sections:
■ Objectives on page xiii
■ Audience on page xiii
■ Documentation Conventions on page xiii
■ SRX Series Documentation and Release Notes on page xv
■ Obtaining Documentation on page xv
■ Documentation Feedback on page xvi
■ Requesting Technical Support on page xvi
Objectives
This guide describes hardware components and installation, basic configuration, and
basic troubleshooting procedures for the Juniper Networks SRX100 Services Gateway.
It explains how to prepare your site for the services gateway installation, unpack and
install the hardware, power on the services gateway, perform initial software
configuration, and perform routine maintenance. After completing the installation
and basic configuration procedures covered in this guide, see the JUNOS Software
configuration guides for information about further JUNOS Software configuration.
Audience
This guide is designed for network administrators who are installing and maintaining
a Juniper Networks SRX100 Services Gateway or preparing a site for device
installation. To use this guide, you need a broad understanding of networks in general
and the Internet in particular, networking principles, and network configuration. Any
detailed discussion of these concepts is beyond the scope of this guide.
Documentation Conventions
Table 1 on page xiv defines the notice icons used in this guide.
Objectives ■ xiii