EasyManuals Logo

Juniper SRX100 Hardware Guide

Juniper SRX100
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Table 7: SRX100 Services Gateway Built-In Hardware Interfaces
DescriptionSpecificationsInterface Type
The Fast Ethernet ports can be used:
To provide LAN connectivity to
hubs, switches, local servers, and
workstations.
To forward incoming data packets
to the device.
To receive outgoing data packets
from the device.
The Fast Ethernet ports:
Consist of eight fixed ports
Are labeled as port 0/0 to port 0/7
on the front panel
Provide link speeds of 10/100 Mbps
Operate in full-duplex and
half-duplex modes
Support flow control
Support autonegotiation
Support autosensing
Fast Ethernet
The USB port can be used:
To support a USB storage device
that functions as a secondary boot
device in case of the internal flash
failure on startup, if the USB
storage device is installed and
configured
NOTE: You must install and configure
the USB storage device on the USB port
to use it as secondary boot device.
Additionally, the USB device must have
JUNOS installed.
To provide the USB interfaces that
are used to communicate with
many types of Juniper-supported
USB storage devices
The USB port:
Consists of one port
Supports the following modes:
Full speed
High speed
Complies with USB revision 2.0
Universal Serial Bus (USB)
The console port can be used:
To provide the console interface.
To function as a management port
to log into a device directly.
To configure the device using the
CLI.
The console port:
Consists of one port
Uses an RJ-45 serial cable connector
Supports the RS-232 (EIA-232)
standard
Console
NOTE: The Reset Config button is used to remove the current configuration and reset
the device to the default configuration.
The button is recessed in the front panel to prevent it from being pressed accidentally.
SRX100 Services Gateway Built-In Interfaces 9
Chapter 2: SRX100 Services Gateway Hardware Components and Specifications

Table of Contents

Other manuals for Juniper SRX100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX100 and is the answer not in the manual?

Juniper SRX100 Specifications

General IconGeneral
Routing protocolsBGP, IS-IS, MPLS, OSPF
Switching protocolsVLAN 802.1Q, 802.3ad/LACP, STP
Supported network protocolsIPv4, IPv6, CLNS
Firewall securityYes
Security algorithms3DES, DES
Authentication methodRADIUS, RSA SecureID, LDAP
VPN supportIPsec VPN
Data transfer rate0.1 Gbit/s
Input voltage100 - 240 V
Input frequency50/60 Hz
Heat dissipation35 BTU/h
Power requirements100-240, 50/60
Power over Ethernet (PoE)No
Power consumption (typical)30 W
SafetyUL 60950-1, CSA 60950-1, AS / NZS 60950-1, AS / NZS 60950-1, CB Scheme, EN 60950-1
CertificationFCC Class B ICES class B AS / NZS CISPR22 Class B AS / NZS CISPR22 Class B VCCI Class B EN 55022 Class B, EN 300386
Mounting typeRack mounting
Internal memory1024 MB
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 40 °C
Weight and Dimensions IconWeight and Dimensions
Weight1100 g
Dimensions (WxDxH)216 x 147 x 36 mm

Related product manuals