Figure 21: SRX210 Services Gateway Desk Installation — Placing the
Services Gateway on a Desk
Related
Documentation
SRX210 Services Gateway General Safety Guidelines and Warnings on page 47•
• Required Tools and Parts for Installing and Maintaining the SRX210 Services Gateway
on page 78
• Preparing the SRX210 Services Gateway for Desk-Mount Installation on page 88
• Installing the SRX210 Services Gateway in a Rack on page 95
• Installing the SRX210 Services Gateway on a Wall on page 100
Installing the SRX210 Services Gateway on a Wall
You can install the SRX210 Services Gateway on a wall.
NOTE: The wall-mounting kit is not shipped with the device and must be
ordered separately.
To install the device on a wall:
1. Place the device on a flat and level surface with Juniper Networks logo embossed on
the top cover facing up. Ensure that rubber feet are attached to the bottom of the
chassis.
2. Position a mounting bracket on each side of the chassis as shown in Figure 22 on
page 101.
Copyright © 2012, Juniper Networks, Inc.100
SRX210 Services Gateway Hardware
To Next Page
Loading...
