Juniper SRX210 Series - Monitoring the SRX210 Services Gateway Components Using Leds

Alarm time Class Description
2009-05-11 10:47:47 UTC Major SRX210 Chassis Fan Failure
Related
Documentation
Monitoring the SRX210 Services Gateway Components Using LEDs on page 147•
• Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 149
• Monitoring the SRX210 Services Gateway Power System on page 152
• Maintaining the SRX210 Services Gateway Hardware Components on page 141
• Juniper Networks Technical Assistance Center on page 155
Monitoring the SRX210 Services Gateway Components Using LEDs
Table 44: Component LEDs on the Services Gateway
Possible Causes and
Corrective ActionsMeaningStateLED
Normal condition. No action
is required.
Indicates that the device is
functioning normally.
GreenStatus LED
Normal condition. No action
is required.
•
The device is starting up.
•
The Reset Config button
is pressed.
Amber
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See “Juniper Networks
Technical Assistance
Center” on page 155.
An error is detected in the
device.
Red
147Copyright © 2012, Juniper Networks, Inc.
Chapter 20: Monitoring Hardware Components