}
interfaces {
ge-0/0/0 {
unit 0 {
family inet {
address 192.168.1.1/24;
}
}
}
lo0 {
unit 0 {
family inet {
address 172.16.1.24/32;
}
}
}
}
18. Commit the configuration to activate it on the device.
[edit]
admin@# commit
19. Optionally, configure additional properties by adding the necessary configuration
statements. Then commit the changes to activate them on the device.
[edit]
admin@host# commit
20. When you have finished configuring the device, exit configuration mode.
[edit]
admin@host# exit
admin@host>
Related
Documentation
Connecting an SRX210 Services Gateway to the CLI Locally on page 118•
• Connecting an SRX210 Services Gateway to the CLI Remotely on page 120
• Performing Initial Software Configuration on the SRX210 Services Gateway Using the
Setup Wizard
• SRX210 Services Gateway Software Configuration Overview on page 125
• SRX210 Services Gateway Secure Web Access Overview on page 137
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface
This topic describes how to perform the initial configuration of your services gateway
using the J-Web setup wizard that is available in Junos OS Release 11.2R2 or earlier. If
your services gateway is running Release 11.2R3 or later, see Performing Initial Software
Configuration on the SRX210 Services Gateway Using the Setup Wizard.
131Copyright © 2012, Juniper Networks, Inc.
Chapter 17: Configuring Basic Settings
To Next Page
Loading...
