CHAPTER 10
Installation Overview
•
Installation Overview for the SRX210 Services Gateway on page 77
•
Required Tools and Parts for Installing and Maintaining the SRX210 Services
Gateway on page 78
Installation Overview for the SRX210 Services Gateway
After you have prepared your installation site, you are ready to unpack and install the
services gateway. It is important to proceed through the installation process as shown
in Table 27 on page 77.
Table 27: Installation Process Order for the SRX210 Services Gateway
For more information, seeTaskStep
“SRX210 Services Gateway General
Safety Guidelines and Warnings” on
page 47
Review the safety guidelines
explained.
1
“Site Preparation Checklist for the
SRX210 Services Gateway” on
page 37
Verify that you have prepared your
site for the installation of the services
gateway using the checklist.
2
“Unpacking the SRX210 Services
Gateway” on page 81
Unpack the services gateway and
verify that the parts are received.
3
“Preparing the SRX210 Services
Gateway for Rack-Mount,
Desk-Mount, and Wall-Mount
Installation” on page 85
Prepare the services gateway for
installation.
4
•
Installing the SRX210 Services
Gateway in a Rack on page 95
•
Installing the SRX210 Services
Gateway on a Desk on page 99
•
Installing the SRX210 Services
Gateway on a Wall on page 100
Install the services gateway.5
“Connecting and Organizing Interface
Cables to the SRX210 Services
Gateway” on page 106
Connect cables to external devices.6
77Copyright © 2012, Juniper Networks, Inc.
To Next Page
Loading...
