Figure 22: SRX210 Services Gateway Wall Installation — Attaching the
Mounting Brackets
Table 35 on page 101 lists the parts used for installing the SRX210 Services Gateway
on a wall. The numbers in Figure 22 on page 101 correspond to the numbers in Table
35 on page 101.
Table 35: SRX210 Services Gateway Wall Installation Parts
PartNumbers
Mounting brackets1
Screws (mounting bracket)2
3. Use a number-1 Phillips screwdriver to install the screws that secure the mounting
brackets to the chassis.
4. If you are using wall anchors to support the chassis, install two pairs of anchors on
the wall with the mounting brackets attached.
5. Have one person grasp the sides of the device, lift it, and position it on the wall.
NOTE: Ensure that the fan (back panel) of your device faces the ceiling
(see Figure 23 on page 102).
6. Have a second person install two pairs of mounting screws through the bracket holes
on either side of the device to secure it to the wall.
7. Verify that the mounting screws on one side are aligned with the mounting screws on
the opposite side and that the device is level (see Figure 23 on page 102).
101Copyright © 2012, Juniper Networks, Inc.
Chapter 13: Installing the Services Gateway
To Next Page
Loading...
