Juniper SRX210 Series - Chapter 9 Interface Cable Specifications and Connector Pinouts; Interface Cable and Wire Specifications for the SRX210 Services Gateway; RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port; Table 23: Cable and Wire Specifications for Ports

CHAPTER 9
Interface Cable Specifications and
Connector Pinouts
•
Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 71
•
RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port on page 71
•
RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port on page 73
Interface Cable and Wire Specifications for the SRX210 Services Gateway
Table 23 on page 71 lists the specifications for the cables that connect to ports.
Table 23: Cable and Wire Specifications for Ports
Device
Receptacle
Maximum
LengthCable/Wire RequiredCable SpecificationPort
RJ-456 ft (1.83 m)One 6-ft (1.83-m) length
with DB-9/RJ-45
connectors
RS-232 (EIA-232) serial
cable
Console
port
RJ-45328 ft
(100 m)
One 15-ft (4.57-m)
length with RJ-45/RJ-45
connectors
CAT-5e (Category 5)
cable or equivalent
suitable for 100BASE-T
operation
Ethernet
port
Related
Documentation
RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port on page 71•
• RJ-45 Connector Pinouts for the SRX210 Services Gateway Console Port on page 73
• SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory, and PoE Versions) on page 9
RJ-45 Connector Pinouts for the SRX210 Services Gateway Ethernet Port
Figure 12 on page 72 shows the RJ-45 cable connector pinouts for Ethernet ports.
71Copyright © 2012, Juniper Networks, Inc.