Juniper SRX210 Series - Configuring Basic System Properties; Table 41: Required Setup Fields

•
Domain search
•
VLANs
•
Interfaces
NOTE: All network and management access settings are optional.
SeeTable 41 on page 133 Table 42on page134 summarize the configuration
details for the initial setup.
6. Click Commit on the Review & Commit page to apply the configuration.
NOTE: After you configure the basic settings, the J-Web Setup wizard
redirects you to the J-Web pages where you can continue working in the
J-Web interface.
Configuring Basic System Properties
Table 41 on page 133 and Table 42 on page 134 summarizes the configuration details for
initial setup.
Table 41: Required Setup Fields
Your ActionFieldSetup Wizard Page
Read the introduction page for
basic instructions on using the
setup wizard. Click Start to
continue.
Introduction
Configure System: Identification
Type the name of the services
gateway.
Hostname
Type the name of the network
or subnetwork to which the
services gateway belongs
Domain Name
Type the password that the
user root will use to log in to the
device.
Root Password (required)
Retype the root password.Verify Root Password
(required)
Configure J-Web Preferences
133Copyright © 2012, Juniper Networks, Inc.
Chapter 17: Configuring Basic Settings