Juniper SRX210 Series - Preparing the SRX210 Services Gateway for Wall-Mount Installation; Table 33: SRX210 Services Gateway Preinstallation Checklist for Wall-Mount

Table 32: SRX210 Services Gateway Preinstallation Checklist for
Desk-Mount Installation (continued)
Additional InformationTask
Verify that you have the following parts available in
your desk-mounting kit to mount the SRX210
Services Gateway vertically:
•
Vertical stand
•
Screws
NOTE: If you are mounting the services gateway horizontally on a desk, verify
that the rubber feet are attached to the chassis.
NOTE: The vertical desk-mounting kit is not shipped with the device and
must be ordered separately.
Related
Documentation
Site Preparation Checklist for the SRX210 Services Gateway on page 37•
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX210 Services
Gateway on page 41
• Unpacking the SRX210 Services Gateway on page 81
• Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 85
• Preparing the SRX210 Services Gateway for Wall-Mount Installation on page 89
Preparing the SRX210 Services Gateway for Wall-Mount Installation
You can mount an SRX210 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Table 33 on page 89 provides the list of tasks you need to perform before installing the
device.
Table 33: SRX210 Services Gateway Preinstallation Checklist for
Wall-Mount Installation
Additional InformationTask
“Site Preparation Checklist for the
SRX210 Services Gateway” on page 37
Verify that the site meets the requirements.
“Unpacking the SRX210 Services
Gateway” on page 81
Remove the services gateway chassis from the
shipping carton.
89Copyright © 2012, Juniper Networks, Inc.
Chapter 12: Installing the Mounting Hardware