Table 11: SRX210 Services Gateway PoE Specifications (continued)
ValuesPower Management Schemes
The following ports support PoE:
•
ge-0/0/0
•
ge-0/0/1
•
fe-0/0/2
•
fe-0/0/3
Supported ports
50 wattsTotal PoE power sourcing capacity
30 wattsPer-port power limit
•
Static: power allocated for each interface
can be configured
•
Class: power allocated for interfaces is
decided based on the class of powered
device connected
Power management modes
The IEEE 802.3 AF (PoE) functionality is supported on SRX210 Services Gateway PoE
models that have power supply of 48V. The IEEE802.3 AT (PoE+) functionality is
supported on SRX210 Services Gateway PoE models that have power supply of 54V. For
more information, see “Adjusting the Power Supply Adapter Tray for the SRX210 Services
Gateway for Rack-Mount Installation” on page 87.
NOTE:
•
The PoE+ functionality is available from Junos OS Release 10.2 or later.
•
The PoE+ functionality is available only if your gateway is using 54V power
supply. You can order the 54V powersupply from Juniper Networks. Contact
yourJuniper Networkscustomerservice representativefor more information.
PoE Classes and Power Ratings
A powered device is classified based on the maximum power that it draws across all
input voltages and operational modes. When the class-based power management mode
is configured on the services gateway, power is allocated by taking into account the
maximum power ratings defined for the different classes of devices.
Table 12 on page 26 lists the classes and their power ratings as specified by the IEEE
802.3 AF standard.
Table 12: PoE Classes and Power Ratings on the SRX210 Services Gateway
Maximum Power Level Output from the PoE
PortClass
15.4 watts0
Copyright © 2012, Juniper Networks, Inc.26
SRX210 Services Gateway Hardware
To Next Page
Loading...
