CHAPTER 16
Establishing Basic Connectivity
•
Connecting to the SRX210 Services Gateway Setup Wizard on page 117
•
Connecting an SRX210 Services Gateway to the CLI Locally on page 118
•
Connecting an SRX210 Services Gateway to the CLI Remotely on page 120
•
Connecting the Modem at the SRX210 Services Gateway End on page 121
•
Connecting the Modem to the Console Port on the SRX210 Services Gateway on page 122
•
Connecting to the CLI at the User End for the SRX210 Services Gateway on page 122
Connecting to the SRX210 Services Gateway Setup Wizard
If you plan to use the setup wizard to configure the SRX210 Services Gateway, you must
connect your management device (such as a laptop or desktop computer) to one of the
built-in Ethernet ports 0/1 through 0/7 as shown in Figure 26 on page 117. Do not use
built-in Ethernet port 0/0.
Figure 26: Connecting to the Ethernet Port on an SRX210 Services Gateway
117Copyright © 2012, Juniper Networks, Inc.
To Next Page
