Juniper SRX210 Series - Page 168

Table 45: SRX210 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Alarm
SeverityActionAlarm ConditionComponent
Amber
(minor)
•
If the internal flash memory fails at startup,
the services gateway automatically boots
from the alternative boot device (USB
storage device).
NOTE: If you configured your services
gateway to boot from an alternative boot
device, ignore this alarm condition.
•
Reformat the internal flash memory, and
install a bootable image. (See the Junos
OS Initial Configuration Guide for Security
Devices and Junos OS Monitoring and
Troubleshooting Guide for Security
Devices.)
•
If you did not configure the services
gateway to boot from an alternative boot
device, contact Juniper Networks Technical
Assistance Center (JTAC). See “Juniper
Networks Technical Assistance Center” on
page 155.
The services
gateway boots from
an alternate boot
device.
Boot media
Red
(major)
•
Contact the Juniper Networks Technical
Assistance Center (JTAC). See “Juniper
Networks Technical Assistance Center” on
page 155.
•
If you must replace the failed Mini-PIM, see
the SRX Series Services Gateways for the
Branch Physical Interface Modules Hardware
Guide for information about replacing the
Mini-PIMs.
A Mini-PIM has
failed.
Mini-Physical
Interface
Module
(Mini-PIM)
Copyright © 2012, Juniper Networks, Inc.150
SRX210 Services Gateway Hardware