KEISOKU GIKEN LOAD EDGE Series - Page 62

Load Edge Series
62 Operations for Load Mode
（7） Example of setting
Ex-1 Continuous operation
Condition: 1A for 1ms at CC mode then 2ms for rest (no load).
1) Set art CC mode at the normal setting screen.
2) Set CC1 at dynamic load setting screen.
3) Set CC2 at dynamic load setting screen.
4) Set Load output “ON”.
5) Press F3 key to select “LOOP” mode then press “ENT” to ON.
This will loop from CC1 to CC16 as so programmed in each CC setting.
*It will skip if the TIME is set as “0”.
Fig. 5-12-7 Continuous operation
O
N
/
O
F
F
(
1
)
(
2
)
(
3
)
(
4
)
(
5
)