Keithley 2016 - Page 157

:TEMPerature
:NPLCycles <n>
:NPLCycles?
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
:AVERage
:TCONtrol <name>
:TCONtrol?
:COUNt <n>
:COUNt?
:STATe <b>
:STATe?
:TCouple
:TYPE <name>
:TYPE?
:RJUNction
:SIMulated <n>
:SIMulated?
Path to configure temperature:
Set integration rate (line cycles; 0.01 to 10).
Query line cycle integration rate.
Specify reference; -200 to 1372
Enable or disable reference.
Query state of reference.
Use input signal as reference.
Query reference value.
Specify measurement resolution (4 to 7).
Query resolution.
Path to configure and control the filter.
Select filter type: (MOVing or REPeat).
Query filter type.
Specify filter count (1 to 100).
Query filter count.
Enable or disable filter.
Query state of digital filter.
Path to configure thermocouple:
Select thermocouple type (J, K, or T).
Query thermocouple type.
Path to configure reference junction:
Specify simulated temperature in °C (0 to 50).
Query simulated temperature.
1
0
OFF
6
(Note)
10
OFF
J
23°C
:FREQuency
:APERture <n>
:APERture?
:THReshold
:VOLTage
:RANGe <n>
:RANGe?
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
Path to configure frequency.
Sets aperture for frequency measurements (0.01 to 1.0s)
Query frequency measurements aperture
Path to select the threshold voltage range:
Select threshold range (0 to 1010).
Query threshold range.
Specify reference (0 to 1.5e7)
Enable or disable reference.
Query state of reference.
Use input signal as reference.
Query reference value.
Specify measurement resolution (4 to 7).
Query resolution.
1.0s
10
0
OFF
7
√
√
Table 5-7 (cont.)
SENSe command summary
Command Description
Default
parameter
SCPI
SCPI Command Reference 5-15