Keithley 2600a series - 10 Triggering

In this section:
Topic Page
Remote triggering overview ............................................................. 10-3
Using the remote trigger model ....................................................... 10-4
Configuring source and measure actions...................................... 10-6
Enabling pulse mode sweeps (end pulse action) .......................... 10-6
SMU event detectors ......................................................................... 10-6
Clearing SMU event detectors ...................................................... 10-7
Using the TRIG key to trigger a sweep ......................................... 10-7
Using trigger events to start actions on trigger objects ................ 10-8
Action overruns ............................................................................. 10-9
Digital I/O Port and TSP-Link synchronization lines...................... 10-9
Common attributes........................................................................ 10-9
Trigger configuration on hardware lines ........................................ 10-10
Action overruns on hardware lines................................................ 10-11
Timers................................................................................................. 10-11
Timer attributes.............................................................................. 10-11
Triggering a timer .......................................................................... 10-12
Using timers to perform pulse mode sweeps ................................ 10-13
Timer action overruns.................................................................... 10-17
Event blenders................................................................................... 10-17
Event blender modes .................................................................... 10-17
Assigning input trigger events ....................................................... 10-18
Action overruns ............................................................................. 10-18
LAN triggering overview ................................................................... 10-18
Understanding hardware value and pseudo line state .................. 10-18
Understanding LXI trigger event designations .............................. 10-19
Generating LXI trigger packets...................................................... 10-19
Logging LAN trigger events in the event log .................................. 10-20
Accessing the event log from the command interface................... 10-22
Command interface triggering ......................................................... 10-22
Section 10
Triggering